Contemporary-control-systems AI-SRVR Servers to Ethernet Installation Guide Uživatelský manuál stáhnout pdf (Strana 5)







Mounting

The AI-SRVR is designed for mounting in an industrial enclosure or wiring

closet using either set of the provided mounting hardware listed below:

TS-35 DIN Rail Mounting Panel Mounting

DIN rail clip Panel mounting bracket

4-40 screws, pan-head (2) 4-40 screws, at-head (4)

For quick snap-mounting onto TS-35 mm DIN rail, a DIN rail clip is

pre-attached to the back of the enclosure with two #4-40 pan-head screws.

If the clip is removed, the unit can be panel-mounted by extending the top

and bottom brackets which are shipped in retracted position. The extended

brackets can then anchor the unit to a wall or other at surface with two #8

pan-head screws (not provided). The left illustration of Figure 1 shows a

rear view of the unit with brackets in retracted position. The right

illustration of Figure 1 shows the brackets extended and secured to the unit

enclosure using the same screws that were used in the retracted position.

Figure 1 — Using the Panel-Mounting Brackets

1 2 3 4 5 6 7 8 9 10 11 12

Žádné komentáře

Contemporary-control-systems AI-SRVR Servers to Ethernet Installation Guide Uživatelský manuál Strana 5